RF SAW Filter
Part Number Package Application Last Modified
802-RF858.5M-A

3.0 x 3.0 SMD

 Wireless Mar. 10, 2007
.
TYPE :
Low Loss RF SAW Filter for Wireless Communication

PART NUMBER :
802-RF858.5M-A
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Condition
 Minimum Typical Maximum Units
Center Frequency (Fo) - - 858.5 - MHz
Maximum Insertion Loss 851.0~ 866.0 MHz - 2.2 3.5 dB
Stop Band Attenuation:
DC~ 806.0 MHz
45 55 -  dB
806.0~ 821.0 MHz
 40 50 -
896.0~ 902.0MHz
28 34 -
905.825~ 924.825 MHz
 27 39 -
960.0~ 979.0 MHz
 37 53 -
1070.0~ 1089.0 MHz
 47 51 -
1089.0~ 3000.0 MHz
 27 32 -
Source Impedence (single ended)*
-
 - 50 - ohm
Load Impendance (single ended)* - - 50 - ohm
VSWR 851.0~ 866.0 MHz - 1.6 2.0 -
Amplitude Ripple 851.0~ 866.0 MHz - 0.6 1.5 dBp-p
Maximum DC Voltage - - - 5 V
Group Delay Ripple 851.0~ 866.0 MHz - 15 40 nsp-p
Maximum Input Power - - - 15 dBm
Operating Temperature - -30 - +70 ºC
* No Matching Network(Ref. Testing Enviroment Circut as shown below)
.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Ground
B

Out
C Ground
D Ground
E In
F Ground
 
TEST FIXTURE
Load/ Source Impedance = 50 ohms
 
FREQUENCY RESPONSE
 
VSWR
 
SMITH CHART
Part No.:
802-RF858.5M-A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map