RF SAW Filter
Part Number Package Application Last Modified
802-RF1472.0M-A

3.0 x 3.0 SMD

 RF Band Pass Mar. 2, 2007
.
TYPE :
RF Band Pass SAW Filter

PART NUMBER :
802-RF1472.0M-A
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Condition
 Minimum Typical Maximum Units
Center Frequency (Fo) - - 1472.0 - MHz
Maximum Insertion Loss 1452.0~ 1492.0 MHz - 3.5 4.5 dB
Attenuation:
DC~ 1300.0 MHz
50 60 -  dB
1300.0~ 1410.0 MHz
 40 50 -
1560.0~ 1620.0MHz
37 42 -
1620.0~ 2500.0 MHz
 35 45 -
2500.0~ 3000.0 MHz
 30 37 -
Source Impedence (single ended)*
-
 - 50 - ohm
Load Impendance (single ended)* - - 50 - ohm
VSWR 1452.0~ 1492.0 MHz - 1.5 2.0 -
Amplitude Ripple 1452.0~ 1492.0 MHz - 0.9 2.0 dBp-p
Maximum DC Voltage - - - 5 V
Maximum Input Power - - - 15 dBm
Operating Temperature - -30 - +85 ºC
* No Matching Network(Ref. Testing Enviroment Circut as shown below)
.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Ground
B

Out
C Ground
D Ground
E In
F Ground
 
TEST FIXTURE
Load/ Source Impedance = 50 ohms
 
FREQUENCY RESPONSE
VSWR
SMITH CHART
Part No.:
802-RF1472.0M-A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map