RF SAW Filter
Part Number Package Application Last Modified
802-RF1215.0M-A

3.0 x 3.0 SMD

 RF Band Pass Mar. 2, 2007
.
TYPE :
RF Band Pass SAW Filter

PART NUMBER :
802-RF1215.0M-A
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Condition
 Minimum Typical Maximum Units
Center Frequency (Fo) - - 1215.0 - MHz
Maximum Insertion Loss 1210.0~ 1220.0 MHz - 2.7 4.0 dB
Attenuation:
1135.0.~ 1175.0 MHz
40 48 -  dB
1320.0~ 1360.0 MHz
 40 55 -
Source Impedence (single ended)*
-
 - 50 - ohm
Load Impendance (single ended)* - - 50 - ohm
Amplitude Ripple 1210.0~ 1220.0 MHz - 0.4 1.5 dBp-p
VSWR 1210.0~ 1220.0 MHz - 1.3 2.0 -
Maximum DC Voltage - - - 5 V
Maximum Input Power - - - 15 dBm
Operating Temperature - -40 - +65 ºC
* No Matching Network(Ref. Testing Enviroment Circut as shown below)
.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Ground
B

Out
C Ground
D Ground
E In
F Ground
 
TEST FIXTURE
Load/ Source Impedance = 50 ohms
 
FREQUENCY RESPONSE
VSWR
SMITH CHART
Part No.:
802-RF1215.0M-A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map