RF SAW Filter
Part Number Package Application Last Modified
800-RF1575.42M-G

1.6 x 2.0 SMD

 GPS Mar. 2, 2007
.
TYPE :
GPS, RF SAW Filter

PART NUMBER :
800-RF1575.42M-G
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Condition
 Minimum Typical Maximum Units
Center Frequency (Fo) - - 1575.42 - MHz
Maximum Insertion Loss 1574.42~ 1576.42 MHz - 1.7 2.2 dB
Attenuation:
DC~ 1400.0 MHz
35 37 -  dB
1400.0~ 1475.0 MHz
 35 38 -
1475.0~ 1525.0MHz
30 35 -
1625.0~ 1640.0 MHz
 40 55 -
1640.0~ 2000.0 MHz
 35 40 -
2000.0~ 3000.0 MHz
 25 29 -
Source Impedence (single ended)*
-
 - 50 - ohm
Load Impendance (single ended)* - - 50 - ohm
VSWR 1574.42~ 1576.42 MHz - 1.15 2.0 -
Amplitude Ripple 1574.42~ 1576.42 MHz - 0.1 1.0 dBp-p
Maximum DC Voltage - - - 5 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -40 - +85 ºC
* No Matching Network(Ref. Testing Enviroment Circut as shown below)
.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Ground
B

In
C Out
D Ground
 
TEST FIXTURE
Load/ Source Impedance = 50 ohms
 
FREQUENCY RESPONSE
VSWR
SMITH CHART
Part No.:
800-RF1575.42M-G

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map