RF SAW Filter
Part Number Package Application Last Modified
805-RF433.92M-D

5.0 x 5.0 SMD

 Remote Control Jan. 01, 2007
.
TYPE :
Remote Control, RF SAW Filter

PART NUMBER :
805-RF433.92M-D
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Condition
 Minimum Typical Maximum Units
Center Frequency (Fo) - - 433.92 - MHz
Maximum Insertion Loss 433.80~ 434.12 MHz - 2.0 4.5 dB
Relative Attenuation:
10.0 ~ 414.0 MHz
45 50 -  dB
414.0~ 428.0 MHz
 40 45 -
428.0 ~ 432.92MHz
15 20 -
434.92 ~ 442.0 MHz
 10 15 -
442.0 ~ 550.0 MHz
 35 40 -
550.0 ~ 1000.0 MHz
 45 50 -
Source Impedence (single ended)*
-
 - 50 - ohm
Load Impendance (single ended)* - - 50 - ohm
Pass Band Ripple 433.76~ 434.16 MHz - 1.0 2.0 -
Maximum DC Voltage - - - 10 V
Maximum Input Power - - - 10 dBm
Operating Temperature - -40 - +85 ºC
* With Matching Network
.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Ground
B

In
C Ground
D Ground
E Out
F Ground
G Ground
H Ground
 
TEST FIXTURE
Source/ Load Impedance = 50 ohms
 
FREQUENCY RESPONSE
 
Part No.:
805-RF433.92M-D

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map