IF SAW Filter
Part Number Package Application Last Modified
803-RF243.95M-A

3.8 x 3.8 SMD

 PHS Jan. 01 2007
.
TYPE :
PHS, RF SAW Filter

PART NUMBER :
803-RF243.95M-A
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency (Fo) - - 243.95 - MHz
Insertion Loss - - 3.0 4.0 dB
Relative Attenutation Fo ± 600 MHz 25 30 -  dB
Fo ± 10.7 MHz 50 65 -
Fo ± 21.4 MHz 60 65 -
Source Impedence (single ended)*
-
 - 50 - ohm
Amplitude Ripple within Fo+/-100KHz
-
 - 0.5 1.0 dB
Group Delay Ripple within Fo+/-100KHz
-
 - 0.4 1.0 us
Load Impendance (single ended)* - - 50 - ohm
Terminating Impedance - - 50 - ohm
DC Voltage - - - 0 V
Input Power - - 0 5 dBm
Operating Temperature - -10 - +60 șC
* With matching network (Ref. Testing Environment Circuit as shown below)
.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Ground
B

In
C Ground
D Ground
E Out
F Ground
 
TEST FIXTURE
Source/Load Impedance = 50 ohms
 
FREQUENCY RESPONSE
 
 
 
SMITH CHART
 
Part No.:
802-RF243.95M-A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map