RF SAW Filter
Part Number Package Application Last Modified
802-RF897.5M-A

3.0 x 3.0 SMD

 EGSM Jan. 01 2007
.
TYPE :
EGSM, RF-Tx SAW Filter

PART NUMBER :
802-RF897.5M-A
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Condition
 Minimum Typical Maximum Units
Center Frequency (Fo) - - 897.5 - MHz
Maximum Insertion Loss 880.0~ 915.0 MHz - 2.5 3.5 dB
Attenuation:
D.C.~ 840.0 MHz
17 23 -  dB
840.0~860.0 MHz
 17 29 -
860.0~ 865.0MHz
10 45 -
925.0~ 935.0 MHz
 4.5 15 -
935.0~ 1850.0 MHz
 20 24 -
1850.0~ 3660.0 MHz
 10 15 -
Amplitude Ripple 880.0~ 915.0MHz - 1.2 2.0 dBp-p
Source Impedence (single ended)*
-
 - 50 - ohm
Load Impendance (single ended)* - - 50 - ohm
VSWR 880.0~ 915.0 MHz - 2.0 2.5 -
Maximum DC Voltage - - - 3 V
Maximum Input Power - - - 15 dBm
Operating Temperature - -10 - +80 ºC
* No Matching Network(Ref. Testing Enviroment Circut as shown below)
.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Ground
B

Out
C Ground
D Ground
E In
F Ground
 
TEST FIXTURE
Load/ Source Impedance = 50 ohms
 
FREQUENCY RESPONSE
VSWR
SMITH CHART
Part No.:
802-RF897.5M-A

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map