RF SAW Filter
Part Number Package Application Last Modified
862-RF1220.0M-E 3.0 x 3.0 SMD Wireless, Balanced RF SAW Filter January 2010

PART NUMBER :
862-RF1220.0M-E

Click for Full Spec (PDF)

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Condition Minimum Typical Maximum Units
Center Frequency - - 1220.0 - MHz
Insertion Loss 1216.0 ~ 1224.0 MHz - 3.0 3.5 dB
Amplitude Ripple 1216.0 ~ 1224.0 MHZ - 0.8 1.3 dB
Group Delay Ripple 1216.0 ~ 1224.0 MHZ - 15 20 ns
Maximum DC Voltage - - - 3 V
Maximum Input Power - - - 15 dBm
Operating Temperature - -40 - +85 C
Storage Temperature - -40 - +85 C
Source Impedance balance ended * - 200 - ohm
Load Impedance balance ended * - 200 - ohm
Attenuation 500.0 ~ 1152.0 MHz 50 55 - dB
1152.0 ~ 1184.0 MHz 44 47 -
1290.0 ~ 2000.0 MHz 50 55 -
* No Matching Network. Ref pdf spec.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A Balanced In
B

Balanced In

C Ground
D Ground
E Balanced Out
F Balanced Out
G Ground
H Ground

TEST FIXTURE and GRAPHS available on PDF.
See FULL PDF SPECIFICATION

Part No.:
862-RF1220.0M-E

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map