IF SAW Filter
Part Number Package Application Last Modified
835-IF44.0M-E 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007
.
TYPE :
44.0 MHz Bandpass Filter
 

PART NUMBER :
835-IF44.0M-E
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency 43.95 44.0 44.05 MHz
Insertion Loss - 24.5 25.5 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
1.0dB Bandwidth 5.4 5.5 - MHz
3.0dB Bandwidth 5.6 5.68 - MHz
40.0dB Bandwidth - 6.45 6.6 MHz
Amplitude Ripple - 0.5 0.8 dBp-p
Group Delay Variation - 65 100 ns
Absolute Delay at Fo - 4.07 - µs
Ultimate Rejection 45 50 - dB
Temperature Coefficient - -94 - ppm/°C
* with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary.
** Custom SAW IF Filters available. Contact Oscilent for assistance.
.
PACKAGE OUTLINE (mm)
PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case
 
TEST ENVIRONMENT
Source & Load Impedance: 50 ohm
 
FREQUENCY RESPONSE
Part No.:
835-IF44.0M-E

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map