Oscilent Corporation IF SAW Filter



	IF SAW Filter

Part Number	Package	Application	Last Modified
824-IF70.0M-WA	24.7 x9.0 SMD	70.0 MHz IF SAW Filter	Jan. 01, 2007

TYPE :

70.0 MHz IF SAW Filter

PART NUMBER :

824-IF70.0M-WA

. .

OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS

PARAMETERS	Minimum	Typical	Maximum	Units
Center Frequency (Fo)	-	70.0	-	MHz
Insertion Loss	-	8.5	12.0	dB
Source Impedance (single ended)*	-	50	-	ohm
Load Impedance (single ended)*	-	50	-	ohm
Temperature Coefficient	-	-0.03	-	ppm/C
Amplitude Ripple within fo+/-50.0Khz	-	0.4	1.0	dBp-p
3dB Bandwidth	0.25	0.33	-	MHz
50dB Bandwidth	-	0.98	1.1	MHz
Relative Attenuation:
from 10.0 to 69.2 MHz	50	57	-	dB
from 70.8 to 110.0 MHz	50	57	-	dB
Absolute Delay at Fo	-	3.22	-	µsec
IN/OUT Return Loss at Fo	-	-	-	dB

*With Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedance values and/or structures, if necessary.

** Custom SAW IF Filters available. Contact Oscilent for assistance.

PACKAGE OUTLINE (mm)

TEST FIXTURE

L1 =	200nH Q>40	L2 =	180nH Q>40
C1 =	100pF	C2 =	51pF
Source/Load Impedance = 50 ohms

Pin Descriptions: IN-10, OUT-5, GROUND- 1,2,3,4,6,7,8,9

FREQUENCY RESPONSE

Part No.:

824-IF70.0M-WA