IF SAW Filter
Part Number Package Application Last Modified
821-IF65.0M-H 20 x9.8 SMD 65.0 MHz IF SAW Filter Jan. 01 2007
.
TYPE :
65.0 MHz IF SAW Filter

PART NUMBER :
821-IF65.0M-H
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency (Fo) - 65.0 - MHz
Insertion Loss - 18.5 20.5 dB
Source Impedance (single ended)* - 50 - ohm
Load Impedance (single ended)* - 50 - ohm
Temperature Coefficient - -72 - ppm/C
Amplitude Ripple within fo+/-9.75Mhz - 0.65 1.0 dBp-p
1dB Bandwidth 9.8 10.00 - MHz
3dB Bandwidth 10.3 10.52 - MHz
40dB Bandwidth - 12.63 12.8 MHz
50dB Bandwidth - 12.82 13.0 dB
Attenuation Rejection
50 55 - dB
Absolute Delay at Fo - 1.67 - µsec
Group Delay Variation - 45 100 nsec
*With Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedance values and/or structures, if necessary.
** Custom SAW IF Filters available. Contact Oscilent for assistance.
.
PACKAGE OUTLINE (mm) TEST FIXTURE


L1 = 68nH L2 = 120nH
C1 = 24pF
-
Source/Load Impedance = 50 ohms
Pin Descriptions: IN-10, OUT-5, GROUND- 1,2,3,4,6,7,8,9
FREQUENCY RESPONSE
Part No.:
821-IF65.0M-H

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map