IF SAW Filter
Part Number Package Application Last Modified
805-IF360.0M-D

5.0 x 5.0 SMD

 Mobile Communication Jul. 03, 2007
.
TYPE :
IF Filter for GSM, PCN system

PART NUMBER :
805-IF360.0M-D
. .
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS Minimum Typical Maximum Units
Center Frequency (Fo) - - 360 - MHz
Insertion Loss (a min.) - - 4.6 5.2 dB
Relative Attenutation Fo ± 0.4 ~ Fo ± 0.6 MHz 35 38 - dB
Fo ± 0.6 ~ Fo ± 0.8 MHz 42 50 -
Fo ± 0.8 ~ Fo ± 1.6 MHz 42 55 -
Fo ± 1.6 ~ Fo ± 5.0MHz 45 55 -
Fo ± 5.0 ~ Fo ± 30.0 MHz 50 57 -
Amplitude Ripple Fo ± 67.7 KHz - 0.8 1.5 dB
Group Delay Ripple Fo ± 67.7 KHz - 0.7 2.0 us
FTC - - 0.032 - ppm/ºC²
Terminating Impedance - - 50 - ohm
DC Voltage - - 0 - V
Input Power - - 5 - dBm
Operating Temperature - 0 - +55 ºC
Storage Temperature - -35 - +85 ºC
* Maximum Rating (Ta = 25ºC)
** Custom SAW IF Filters available. Contact Oscilent for assistance.
PACKAGE OUTLINE (mm)

PIN LAYOUT
A In
B

In or Ground
C Ground
D Ground
E Out
F Out or Ground
G Ground
H Ground
TEST FIXTURE
L1 = 68nH C1 = 7pF
L2 = 74nH C2 = 7pF
Source/Load Impedance = 50 ohms
L1 = 56nH C1 = 5pF
L2 = 56nH C2 = 4.3pF
L3 = 56nH
L4 = 56nH
Source/Load Impedance = 50 ohms
FREQUENCY RESPONSE
Part No.:
805-IF360.0M-D

Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator
Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map